Overview
TwinCut flails
TwinCut is equipped with tough hedge cutting T-flails at the rear and compeition flails at the front.
Featuring not one but two high-powered spiral rotors, the new Twincut Flailhead has been designed to tackle hedgerows in a single-pass - delivering both a heavy-duty cut and a fine finish in a single operation.
The first rotor is equipped with a heavy-duty T-flail which cuts in a downward direction, reducing the amount of debris blown forward. The material is finely mulched and the bulk is retained in the hedgerow.
The second rotor is set 50mm lower, cuts in an upward direction and is equipped with a fine-cut McConnel competition flail. This combination is perfect for shaping the hedge and leaving behind a precise and attractive finish.
Designed to boost the productivity and efficiency of contractors, Twincut's unique double cutting action saves time, cuts fuel costs, and increases the amount of work that can be done in a day.
TWINCUT
"It gives a lovely finish, tackles mature hedges effectively and it’s faster than a normal flailhead. I wouldn’t swap mine for any other flailhead.”
Steve Smith, Worcestershire contractor
Features
- 1.2m and 1.5m working widths
- Unique design
- No need for a front cover
- Effective single-pass cutting
- Boosts productivity
- Increases working speeds
- Dramatic fuel savings
- Reduces damage to fields with fewer wheel markings
- Unique patented design
- Close-cutting
Models
- 1.2m Twincut DD
- 1.5m Twincut DD
TwinCut flailhead in action
See McConnel's innovative TwinCut flailhead in action:
| Suitability | ||
|---|---|---|
| 1.2m Twincut |
1.5m Twincut |
|
| Swingtrim | ||
| 30-series |
||
| 45-series |
||
| 55 ECO-Series | ||
| 55-series |
||
| 60-series |
||
| 65-Series | X | |
| 70-series | X |
|
| 85-series | X |
X |
| VERSI-series | ||
* The Twincut Flailhead is not suitable for machines with telescopic arms
